Hog Slat HS610 Guia Del Usuario página 2

Suggested location of
floor fasteners if only (3)
are used.
Figure 1
.
Figure 3
HS610 AQUABOWL AND HS610-1 AQUAFLO NIPPLE ASSEMBLY · Page 2
U-Bolt and
Back plate
Figure 2
Position water nipple so it is just below
top edge of the bowl.
1. Position HS610 AquaBowl in front corner of crate.
Either left or right (shown) Position so that slots in
AquaBowl align with slots in flooring.
See Figure 1
2. Position HS610-1 water pipe/nipple assembly
along crate sides so that water nipple is presented
to sow as shown. Attached HS610-1 water
pipe/nipple assembly using appropriate sized U-
Bolt and plate to fit crate pipe size. See figure 2
3. HS610 bowl may be fastened to floor using
Cap head bolt and fender washer or
Smart Floor Fastener (if only top access is
available). (see table "Floor Fasteners")
(3 fasteners/bowl minimum)
Four slots are available in the AquaBowl for up to
(4) fasteners