Uline H-1086 Instrucciones

H-1086, H-1087
TIME CLOCK
TO REMOVE CASE COVER
1. Turn key one-quarter turn clockwise.
2. Lift case cover up then forward.
3. Reverse procedure to replace cover.
TO SET TIME AND/OR DATE
NOTE: Unless your recorder is equipped
with continental (0-23) hours, all PM hours
on the time card will be printed underscored
(Ex.: 1:00). To change the time and/or date
follow these steps:
1. Unplug recorder and remove Case Cover.
TO SET DAY/DATE
1. Make sure current time setting is between midnight
and noon (see note above).
2. Push down and release Yellow Lever (See Figure 1)
to set correct day/date.
3. Plug in recorder and punch card to verify correct
setting. Repeat steps 1-3 if reading is incorrect.
TO SET TIME
1. Push down and release Black Lever to set the correct
time. (See Figure 1) If Black Lever does not work, plug
in recorder and wait for minute hand to advance,
then unplug recorder and try lever again. DO NOT
MOVE CLOCK HANDS TO SET THE TIME.
TO SET MONTH
1. Turn Month Knob counter-clockwise to select correct
month. (See Figure 1)
2. Plug in recorder and punch card to verify correct
setting. Repeat steps 1-2 if reading is incorrect.
PAGE 1 OF 12
1-800-295-5510
uline.com
INSTRUCTIONS
Figure 1 (front view with cover removed)
Black Lever
(time)
IMPORTANT NOTES
1. The date setting MUST be manually reset to the first
of the month each month following any month with
less than 31 days.
2. The month settings MUST be manually reset every
month.
3. To reset the recorder after a power failure
repeat steps from "TO SET TIME AND/OR DATE."
4. HINT: If clock is set slightly ahead of actual time,
unplug it until it matches the correct time.
Para Español, vea páginas 5-8.
Pour le français, consulter les pages 9-12.
Month Knob (turn counter-clockwise)
Yellow Lever
(day/date)
0721 IH-1086