4
Mounting Levers
3. Rotate each lever in the direction indicated until lever is in final latch
position. Follow the latching sequence below to obtain optimum terminal fit.
Use the table below as a guide to insure an adequate gasket seal between
terminal and panel.
3
4
5
6
Terminal Markings
for Alignment
ATTENTION
!
Publication 2711P-IN016A-MU-P
Rotate until notch in levers
align with proper alignment
mark on terminal.
Lever Position
1
2
1
2
3
4
5
6
Follow instructions above to provide a proper seal and
to prevent potential damage to the terminal.
Allen-Bradley assumes no responsibility for water or
chemical damage to the terminal or other equipment
within the enclosure because of improper installation.
1
6
Notch
Alignment Marks
Panel Thickness Range
0.15 - 2.01 mm (0.060 - 0.079 in)
2.03 - 2.64 mm (0.08 - 0.104 in)
2.67 - 3.15 mm (0.105 - 0.124 in)
3.17 - 3.66 mm (0.125 - 0.144 in)
3.68 - 4.16 mm (0.145 - 0.164 in)
4.19 - 4.75 mm (0.165 - 0.187 in)
1
4
4 Levers
3
2
1
5
6 Levers
4
2
Typical Gauge
16
14
12
10
8/9
7
3
6