Bluetooth; Pairing And Connecting With A Cell Phone - Sensear SM1 Manual Del Usuario

BLUETOOTH

Confi guring the SM1x(SR) to be a Bluetooth headset for a cell phone is a two-step process.
Firstly, the SM1x(SR) must be paired with the cell phone. Secondly, the SM1x(SR) must be connected
to the cell phone. Pairing is required only once. When completed, each time the SM1x(SR) is powered
up, the SM1x(SR) automatically connects to the cell phone it was last paired with.

Pairing and Connecting with a Cell Phone

Pairing represents the exchange of a security key to enable secure communications between the
SM1x(SR) and the cell phone. To complete pairing, the following steps should be followed:
Step 1. Enter "Pairing Mode", which makes the Bluetooth module on SM1x(SR)
discoverable:
•
Press and hold the "Multi-Function" button for fi ve seconds. The Blue LED will illuminate solid blue
and an audible message will be played. The user can now use a cell phone to fi nd the Sensear
SM1x(SR) and commence the pairing process.
Step 2. Find the SM1x(SR) on a cell phone:
• Ensure that Bluetooth is enabled on the cell phone. Perform a search for Bluetooth devices on
the cell phone and select Sensear SM1x(SR) from the list of discovered devices.
Step 3. Enter the PIN (Passkey) on the cell phone:
• The PIN (Passkey) is "0000" (zeros). The pairing will then be completed. Note at this point, some
cell phones will automatically connect to the SM1x(SR). If so, Step 4 is not required.
Following pairing, the Sensear SM1x(SR) will be stored in the list of paired devices on your cell
phone. Similarly, your cell phone is stored in the memory of the SM1x(SR).
Step 4. Connect the SM1x(SR) to the cell phone:
• Press and hold down the "Volume Down" button for one second. An audible message will play,
notifying the user that the SM1x(SR) is attempting to connect to the cell phone. When connection
is completed successfully, the SM1x(SR) plays the message "Connection Completed" and the
Blue LED fl ashes at the normal rate. On some cell phones the user may have to "authorise" the
SM1x(SR) to complete the connection.
IMPORTANT NOTES:
The SM1x(SR) stores pairing information for only ONE cell phone at a time. Each cell phone
paired over-writes the previously paired phone in the memory of the SM1x(SR). Any cell
phone that is not registered in the memory of the SM1x(SR), regardless if it has previously
been paired, will require pairing with the SM1x(SR) again.
If pairing is not completed within two minutes after entering "Pairing Mode", the system will
leave "Pairing Mode" and notify the user with a message.
NOTE: The SM1x(SR) can only enter the "Pairing Mode" if the two-way radio interface is
NOT operational. Ensure that the two-way radio is unplugged before attempting to enter the
"Pairing Mode". Alternatively, leave the two-way radio plugged into the system, ensuring
that the radio is turned off.
NOTE: The SM1x SR can only enter the "Pairing Mode" if Short Range Communication is
NOT operational. Short Range Communication may be enabled in the User Menu, but must
be 'OFF' (simultaneous press on "Volume-Up" and "Volume-Down") before attempting to
enter "Pairing Mode".
6