Publicidad
Idiomas disponibles
Idiomas disponibles
Scanning
STUD and DEEP scan
1
2
33
1.After calibration has finished, slowly slide the
unit across wall in a horizontal direction. Make
sure not to tilt or lift the tool.
2.As you begin to approach a stud, the sequential
levels on the LCD will increase.
3.Peck at the stud edge. Mark this spot to
indicate stud edge.
4.Continue scanning beyond the marked spot
until the peak level disappears.
5. Then slide the unit in reverse direction to
locate the other edge of stud .Mark this second
spot.
3
Mark this point
ELECTRONIC STUD SENSOR
4
Mark
this point
5
34
Publicidad
