Transferring The Ups To Bypass Mode; Operating Modes - Eaton Powerware 9125 Guia De Instalacion

Transferring the UPS to Bypass Mode

NOTE When the UPS is in Bypass mode, Battery mode is not available and the UPS does
not protect against power outages; however, the utility power continues to be passively
filtered by the UPS.
Press the On button for approximately eight seconds to transfer the
UPS to Bypass mode. The
Press the On button again for approximately three seconds to return to
Normal mode.

Operating Modes

Powerware 9125's front panel indicates the UPS status through the UPS
indicators. Figure 34 shows the UPS front panel indicators and controls.
Normal Mode Indicator
Battery Mode Indicator
Bypass Mode Indicator
Test/Alarm Reset Button
®
EATON Powerware
Off Button
Figure 34. UPS Front Panel
9125 (9910-P64) UPS Installation Guide for IBM
indicator illuminates.
Alarm Indicators
Bar Graph Indicators
Indicator Legend
On Button
® S
Applications 164201637 Rev A
OPERATION
Unlit
Lit
Flashing
37