Printer Setup - Selecta UV 3100 Manual De Instrucciones

INSTRUCTION MANUAL CODE 80260 REV A
Fig. 4.20
Fig. 4.21
J
.P. SELECTA s.a.u.
Feb/2017
5.4.1 Wavelength Reset
After some time, the energy of lights would drop off and there will be some
but slight influence on the test result. In this case, user's can reset the
wavelength to compensate. We suggest the user's to reset the wavelength
every one or two months.
Press [1] or use
to begin the calibration. During the course, opening the lid of the compartment is
prohibited.

5.4.2 Printer Setup

Press [2] or
confirm (Fig. 4.21).
•
Reset Printer
Press [1] or use
confirm. Then the printer will resume the initial condition.
•
Select print port
Press [2] or use
confirm. Use
to confirm.
•
Select Printer
Press [3] or use
confirm. Use
to confirm.
•
Change Print Mode
Press [4] or use
to confirm. Two modes are under your choice, one is «Print Data Sheet», and the
other is «Print the display interface».
5.4.3 Lamp Service
Press [3] or use
into «lamps management» screen (Fig.4.22).
Ctra. NII Km 585.1 Abrera 08630 (Barcelona) España
e-mail: selecta@jpselecta.es - website: http://www.jpselecta.es
(It can be modified without notice)
to choose «Wavelength Reset», then press [ENTER]
&
& to select «Printer Setup» and then press [ENTER] to
, to choose «Reset Printer» and press [ENTER] to
to choose «Select print port» and press [ENTER] to
&
to choose «LPT» or «Comm» and then press [ENTER]
&
to choose «Select printer» and press [ENTER] to
&
to select the printer's model and then press [ENTER]
&
to choose «Change print mode» and press [ENTER]
&
to choose «Lamp Service», press [ENTER] to go
&
Page: 48
Tel 34 93 770 08 77 Fax 34 93 770 23 62