Overheat Protection; Overload Protection - Philips SatinSoft HP6523/20 Manual De Instrucciones

ENGLISH
10
2 Put the shaving head on the appliance (1) and push it against the
direction of the arrows on the back of the appliance (2) to fix it.
3 Switch on the appliance.
4 Stretch the skin with your free hand. When shaving the underarms,
raise your arm to stretch the skin.
5 Place the appliance onto your skin, with the on/off button pointing in
the direction in which you are going to move the appliance.
6 Move the appliance against the direction of hair growth.
Note: Make sure that the shaving foil with integrated trimmer is always fully in
contact with the skin.
- Shave your bikini line as shown in the figure. Move the appliance in
different directions.
- Shave your underarms as shown in the figure. Move the appliance in
different directions.
7 When you have finished shaving, switch off the appliance and clean
the shaving head (see chapter 'Cleaning and maintenance').

Overheat protection

This function helps to prevent overheating of the appliance.
Note: To avoid overheating of the epilator, do not press the appliance too
hard onto your skin. The epilator works best when you move it over your skin
without exerting any pressure.
If the overheat protection is activated, the appliance switches off
automatically and the charging light flashes red for 30 seconds.
To reset the overheat protection, let the appliance cool down and then
switch it on again.
Note: If the charging light starts to flash red again, the appliance has not yet
cooled down completely.

Overload protection

If you press the epilating head too hard onto your skin or when the
epilating discs of the epilating head get blocked (e.g. by clothes etc.), the
appliance switches off and the charging light flashes red for 5 seconds.
Turn the epilating discs with your thumb until you can remove whatever is
blocking the epilating discs.