Descargar Imprimir esta página

Acoem OneProd Eagle Manual Del Usuario página 5

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

2.
S
ENSORS AND EXPANDERS
2.1.
I
DENTIFICATION
2.2.
I
NSTALLATION
During installation or disassembly of EAGLE devices, the operator must wear the prescribed
PPE (Personal Protective Equipment), respect the regulations in force and have the necessary
clearances.
WARNING: In hazardous environments, the operator has to arrange organizational safety
measures which reliably prevent the occurrence of an ignitable atmosphere, by default reduce
the probability that a flammable atmosphere can occur at all (using suitable gas detection
systems).
A damp cloth should be used when installing or taking off the sensors and expanders in all
hazardous areas to eliminate static electricity resulting from this operation.
Only use the dedicated tube wrench to fasten or unfasten sensors/expanders.
Only use your hands or a rubber strap wrench to remove the protection tube from the
sensor/expander. The use of tongue-and-groove pliers (also known as water pump pliers,
adjustable pliers, groove-joint pliers, arc-joint pliers, Multi-Grips, and Channel locks) is
forbidden and will cause damages to and loss of sealing IP67.
CAUTION:
Table 2: Sensors and expander part numbers
Model
EGL1102000
EGL1103000
EGL1104000
/
DISASSEMBLY
Do not grasp the sensor by the plastic cap.
Do not hit the plastic cap.
Do not tighten the sensor by the plastic cap
Figure 1 : Sensor installation tools
Device
Uni-axial sensor
Tri-axial sensor
Expander
5
Brand of ACOEM

Publicidad

loading