TUTTI bambini Versati Manual De Instrucciones página 15

• Slot the two buckle connectors into the slot in the top of the buckle until they "click"
into place (Fig. 4.4.1-2).
• Check the harness is correctly locked by pulling the shoulder straps Upwards (Fig.
4.4.1-3).
• To release the harness, press the red button on the buckle downwards.
5. Usage for groups II and III (15 up to 36kg)
The harness system must be removed from the seat (see point 5.1) when used for these
age groups 15kg up to 36kg. Only the 3-point vehicle belt system can be used to buckle
up the child car seat.
5.1 Removal of the harness
• Loosening the harness (see point 4.3). Turn the seat to the back.
• Slide both of the harness straps o the harness connector (Fig. 4.1-3).
• Remove the buckles located on the back of the child car seat (Fig. 4.1-4).
• Remove the belt buckles from the slots and pull until they come out of the fabric
together with the metal buckles (Fig. 5.1-1).
• Now you can remove the belts as well as the tongue in an upwards direction (Fig.
5.1-2).
• Installation of the harness is carried out in reverse order to removal.
• Keep harness with all parts in a safe place, to use in the future.
5.2 Height adjustment of headrest
• Regularly check whether the head rest is optimally to your child. The height of the
head rest is set optimally to the size of your child, when their headrest comfortably in
the middle of the headrest.
• To raise or lower the head rest: pull the head rest adjustment handle (J) - Fig. 5.2.
5.3 Securing the child car seat with vehicle's belt
The vehicle's 3-point belt system may only be used to buckle up children of the age
groups II and III (15kg up to 36kg).
The harness system must be removed from the seat (see point 5.1) when used for these
age groups 15kg up to 36kg.
Step 1: Place the child safety seat on the vehicles seat ensuring it is firmly pressed
against the car seat backrest (Fig. 5.3-1).
Step 2: Seat your child in the child car seat (Fig. 5.3-2).
Step 3: Pull out the 3-point vehicle belt and place the lap belt on the opposite side of
the buckle under the armrest (make sure that the diagonal belts and the lap belt on the
buckle side are under the armrest). The lap strap should be worn low down, so that the
pelvis is firmly engaged and the straps should not be twisted. And allow it to the buckle
in place. You will hear "click" (Fig. 5.3-3).
Step 4: Place the diagonal belt goes through the Head belt guide (K) on the side of the
headrest. Make sure that the belt is not twisted.
15