DJI THUMBWHEEL Guia Del Usuario página 9

• The Thumbwheel currently supports RED cameras with Canon
Electronic lenses and firmware V5.3.49 or above is required.
• The RED camera will switch to manual focus mode if a lens was
replaced while the camera was powered off.
Operation
Motor Calibration
Calibrate the motor every time after it is turned on so that it can find the end
points on a lens.
Press the DIR button and the LENS button simultaneously to start calibration.
Calibration is complete when the system status indicator goes solid green.
Pressing the DIR button and the LENS button simultaneously during calibration
will stop the process.
Calibration is not necessary when using the Thumbwheel to control
RED Cameras with Electronic Lens. Press the DIR and LENS button
simultaneously to use the Thumbwheel to pause/resume control of the
lens.
Travel Range Settings
1. Turn the focus wheel on the Thumbwheel to the desired upper travel limit
and press the LENS button once.
2. Turn the focus wheel on the Thumbwheel to the desired lower travel limit and
press the LENS button once again.
3. Now turning the focus wheel a full cycle will rotate the lens between the two
travel limits.
Press and hold the Lens button to reset the travel range.
Switching Rotation Direction
Press and hold the DIR button to reverse the rotate control direction.
LENS Button
DIR Button
©
2017 DJI All Rights Reserved.
7