Using Manual Mode; Care And Cleaning - Defiant DFI-5998-BK Guía Para El Uso Y Cuidado

Operation (continued)
2
Determining the motion sensor
detection zone
NOTE: The motion sensor (C) is non-adjustable. It has a
sensing angle of 180° and a range of approximately 40 ft.
depending on the surrounding temperature.
NOTE: The motion sensor (C) will need to completely
warm up (60 seconds) before beginning the setup process.
The light will only operate at night.
□
Perform a "walk test": walk in an arc across
the front of the motion sensor (C).
□
Watch the light (B). The light (B) will come on
indicating motion has been detected.
□
Stop, wait for the light (B) to turn off, and then
begin walking again.
□
Continue this process until the detection zone
has been established.
3

Using manual mode

NOTE: Manual mode overrides the motion sensor (C) so
the light will operate full bright. This feature only works
at night and only for one night at a time. The motion
sensor (C) will reset to motion sensing mode after 6 hours
or sunrise, whichever comes first. Manual mode can be
toggled on and off using a wall switch.
□
Ensure the power to the light is ON and the
sensor has warmed up (60 seconds).
□
To turn manual mode on, switch the power
OFF–ON–OFF–ON at the wall switch within 3
seconds.
□
To turn manual mode off, switch the power
OFF–ON–OFF–ON at the wall switch within 3
seconds.

Care and Cleaning

□
To prolong the original appearance, clean with clear water and a soft, damp cloth only.
□
Do not use paints, solvents, or other chemicals on this light fixture. They could cause a premature
deterioration of the finish. This is not a defect in the finish and will not be covered by the warranty.
□
Do not spray with a hose or power washer.
C
NOTE: If the power to the light fixture is off for more than
5 seconds, allow the motion sensor to warm up prior to
switching to manual mode.
OFF ON
Less than 3 seconds
7
Please contact 1-866-308-3976 for further assistance.
B
OFF ON
HOMEDEPOT.COM