Publicidad
Idiomas disponibles
Idiomas disponibles
IV
After each cycle
IMPORTANT: Allow the unit to cool for at least two minutes
before removing the sterilizer from the microwave.
1. Removing the sterilizer from the microwave: After
the unit has cooled, remove it from the microwave
by holding the skirt and/or safety grips and then
place on an even, heat-resistant surface.
NOTE: Items will remain sterile in the AVENT Express II Microwave
Steam Sterilizer for up to 24 hours providing the lid is not removed.
2. After removing the sterilizer from the microwave:
Remove the lid by unlocking the clips – When removing
the lid, point it away from you to allow steam to escape.
Care and cleaning
• Always drain the excess water from the unit and
rinse to prevent the build up of limescale.
• Always store when completely dry.
• The AVENT Express II Microwave Steam Sterilizer
is dishwasher safe.
E
Loading one VIA Disposable Nurser* and up to
four 6oz/180ml OR 8oz/240ml VIA Cups and Lids
1. Position the nipple in an outer nipple cavity.
2. Place the screw ring over the nipple.
3. Position the VIA Cups upside down around
the dome cap stem.
4. Place the VIA Adaptor on its side around the
racks edge (as shown).
5. Position the VIA Lids vertically around the racks
edge. Rims should face out for easier loading.
6. Place the dome cap in the unobstructed upper
slot of the dome cap stem.
Loading other feeding and baby product items
When sterilizing other NON-ELECTRICAL AVENT PRODUCTS
simply place the components in the rack allowing
enough space so that steam can effectively circulate.
NOTE: Do not overload the sterilizer.
NOTE: Do not place dome caps in the sterilizer upside down.
NOTE: The AVENT Express II Microwave Steam Sterilizer is
designed to specifically hold the wide shape of AVENT Natural
Feeding Bottles.
* Consists of VIA Cup, Lid and Adaptor, an Extra Soft Slow Flow
Nipple, Dome Cap and Screw Ring
WARNINGS –
FAILURE TO FOLLOW INSTRUCTIONS MAY
CAUSE SCALDING OR DAMAGE TO THIS
PRODUCT AND/OR YOUR MICROWAVE
• Always ensure you use 200ml of water
before sterilizing. (The unit should be
emptied of residual water before each
subsequent use.)
• Always follow loading instructions and
do not overload.
• Do not use bleach or chemical sterilizing
solutions/tablets in sterilizer or on
products to be sterilized.
• Do not sterilize metallic or electronic items
in the sterilizer.
• Do not microwave bottle brush.
• Always use the appropriate heating time
for the power of your microwave unit.
(see Table
)
III
• In combination ovens, ensure grill is
switched off and has cooled before use.
• Be sure that the lid is properly fastened to
the base before placing in microwave.
• Always allow at least 2 minutes cooling
time before removing from the microwave.
• Do not remove the lid from the sterilizer
immediately after cycle. Allow to cool as
the steam will be hot.
• When removing from microwave, be sure
to hold the sterilizer level to avoid leaking
or spilling of hot water.
• When taking the sterilizer out of the
microwave, BE CAREFUL – it will still be hot.
• When removing the lid, point it away from
you to allow steam to escape.
• Be careful when handling the sterilized
products as they may be hot.
• Always keep out of reach of children.
Some products featured may not be available in all
countries. Please contact AVENT to check availability.
AVENT® is here to help
1.800.54.AVENT
www.aventamerica.com
US
9
Publicidad
