Tripp-Lite MTB3-DOCK-02 El Manual Del Propietario página 4

Installation
Notes:
• Supports the connection of two monitors at the same time through DisplayPort
MST mode*
• When the included 120W (20V/6A) power supply is connected to the DC port, it
supplies power to charge the host PC first, with the rest of the power supplied to
the dock.
• See Optional Accessories for recommended cables.
• When the unit is connected to the USB-C port on the computer and to a network
via Cat5e/6 cabling, a network connection will be established automatically. If no
connection is made, you can establish one manually by going to your computer's
network settings page. For example, on a Mac, navigate to the Network section
found in System Preferences, click the "Assist Me" button to get to the Network
Setup Assistant, then follow the prompts to establish a connection.
*see Multi-Monitor Requirements section for details.
1. Connect the included power supply between the unit and a power
source.
2. Connect a Thunderbolt 3 enabled laptop or computer to the unit's
Thunderbolt 3 host port using the included Thunderbolt 3 cable.
3. Connect a 3.5 mm mini stereo cable to the back of the unit to connect
a speaker.
4. Connect up to four USB devices to the dock's USB-A ports.
5. Connect the adapter's RJ45 port to a network using a UTP cable.
6. Connect the dock's VGA port to the VGA port on a monitor using a VGA
cable.
OR
Connect the dock's HDMI port to the HDMI port on a monitor using a
HDMI cable.
OR
Connect the dock's DisplayPort port to the DisplayPort port on a monitor
using a DisplayPort cable.
7. Connect a 3.5 mm mini stereo cable to the front of the unit to connect
a microphone or headphones.
4