Basic Troubleshooting; Product Disposal - Nice Nemo SCT Instrucciones Y Advertencias Para La Instalación Y El Uso

Setting the "Sun" and "Wind" sensor setpoints
(fig. 4)
01. Turn the "Sun" trimmer to the desired setting.
Important – Setting the trimmer to its maximum
value (at the end of its CW rotation) disables the
Sun sensor.
02. Turn the "Wind" trimmer to the desired setting (if
present).
03. Make sure that Led "L1" flashes red and green al-
ternately.
04. To terminate the procedure, wait for the flashing to
stop.
7 - DIAGNOSTICS
You can enable "DIAGNOSTICS mode" at any time to
check whether the weather conditions at the time are
above or below the setpoint values and to identify mal-
functions.
To enable diagnostics, press "P1" briefly and wait 1
second for the red Led to stop flashing. Now watch
the Led and check the sequences of flashes against
Table A. Note – If several thresholds are exceeded
during normal operation (for example, wind and rain to-
gether), the diagnostics signals only the one which has
the lower number in Table A.
Caution! – Diagnostics mode can only be used for
reading signals off the Leds, not for operating the
awning.
4
01 02
2
sec.
OFF
Off Wait
Note – To check whether the device is really faulty,
simply run the calibration procedures given in chap-
ter 5.

8 - BASIC TROUBLESHOOTING

If the wind or sunlight are stronger than their re-
spective trip values but the motor does not re-
spond as it should, check that the sensor is powered
correctly and memorized in the motor's receiver (see
chapters 3 and 4). If this does not solve the problem,
check the operation of the sensor by running the diag-
nostics described in chapter 7.

PRODUCT DISPOSAL

• This product is an integral part of the automation
and must therefore be scrapped together with it, in the
same way as indicated in the automation's instruction
manual. • Dispose of the product packaging material in
compliance with established local legislation.
03
sun
klx
Desired value...
wind
Km/h
Desired value... (WSCT model)
Table A - Led diagnostics signals
Red Led on(*) (for 3 seconds) = The wind
1
setpoint has been exceeded
Green Led on (for 3 seconds) = The sun
2
setpoint has been exceeded
Red Led flashing(*) (0.5 second intervals for
3 seconds) = Self-test: wind sensor fault. The
3
sensor has not detected variation in the wind
speed in the last 24 hours
Green Led flashing (for 3 seconds) = Self-
test: sun sensor fault. The sensor has not
4
detected variation in the sunlight in the last
24 hours
5
Led off = No setpoint exceeded
(*) = Not present on SCT model
04
"L1" (green-red-)
fast flashing
ON
On  Series of flashes
...
English – 7