Installing The Cooktop - GE JP3021 Manual De Instrucciones

INSTALLING THE COOKTOP

Installing the Junction Box
1
Install an approved junction box where it will be
easily reached through the front of the cabinet
where the cooktop will be located. The cooktop
conduit is 4' long.
Install junction box so
that it can be reached
through the front of the
IMPORTANT: The junction box must be located
where it will allow considerable slack in the
conduit for serviceability.
Protect Surface Of Cooktop
2
Place a towel or tablecloth onto the
countertop. Lay the cooktop upside down onto
the protected surface.
Bottom of Cooktop
Cloth under Cooktop
Attach Foam Tape
3
Apply the foam tape around the outer edge of
the glass. Do not overlap the foam tape.
Bottom of Cooktop
Cooktop
Glass
16
Installation Instructions
5" Min.
cabinet.
Foam Tape
Locate Mounting Parts
4
On the underside of the cooktop, you will find
the hex screws that are noted in the diagram
below. Remove and use these hex screws to
mount the brackets at these two locations. Do
not over-tighten
the screws.
Turn bracket
inward to avoid
interference
when dropping
the cooktop into
the countertop.
Insert Cooktop into Cutout
5
Insert the cooktop centered into the cutout
opening. Make sure the front edge of the
countertop is parallel to the cooktop. Make final
check that all required clearances are met.
Cooktop
Attach Hold-Down Brackets to
6
Cabinet
Open the cabinet door. Rotate the brackets to
overlap with the underside of the countertop. Then
tighten the hex screw. Install the 2-3/8" screw until
it touches the bottom of the countertop.
Cooktop
IMPORTANT: Turn the 2-3/8" screw until it touches
the bottom of the countertop. Do not overtighten.
Hex Screws
Bottom of Cooktop
Countertop
49-2000738 Rev. 3