Bond HYUTT33001-1 El Manual Del Propietario página 4

SAFETY INFORMATION
Only use the regulator and hose assembly provided with this unit. Replacement parts must be supplied
directly by Bond Manufacturing Co., Inc.
Inspect the burner before use of this unit. If the burner shows any kind of damage, do not operate
the appliance. For assistance with repair or replacement of the burner or any other parts, calls Bond
Manufacturing Co., Inc. at 1.866.771.2663.
NOTE: You must follow all steps to properly assemble this heating item. Make sure the gas
valve is turned "OFF" before assembling. Do NOT attempt to assemble without proper tools.
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
Min. Clearance
48 in (121.9 cm)
A table with an umbrella hole (not included) is required to assemble this product
The umbrella hole table size needs to meet the following requirements:
The length and width should not be shorter than 81.28 cm / 32 in.
The height should be lower than 101.6 cm / 40 in.
The tabletop should be incombustible material.
Bond Manufacturing Co., Inc. | Page 4
Combustible materials should not be within 60
Min. Clearance
48 in (121.9 cm)
inches of the top of the unit, or within 48 inches
around the entire unit.
.