Troubleshooting - Kenwood STZ-RF200WD Manual De Instrucciones

Troubleshooting

Issue
The indicator does not light
up even though the vehicle
ACC is ON.
The orange status LED is
blinking. (see p. 1 6)
The display indicates an SD
card error. (see p. 1 6)
The display indicates a front
camera error. (see p. 1 6)
The display indicates a rear
camera error. (see p. 1 6)
The display indicates
that the camera is not
connected while adjusting
the recording angle.
(see p. 1 6)
The display indicates a GPS
error. (see p. 1 6)
The display indicates that
the temperature is high.
(see p. 1 6)
The display indicates a
switch error. (see p. 1 6)
The camera and main unit
will generate heat during
use.
The time displayed on
recorded video is incorrect.
y Is the fuse blown?
3 Address the cause of the blown fuse and replace the fuse.
(Always use fuses of the specified capacity)
y Is the in-line connector for the power cable or switch cable
disconnected?
3 Check the connections of the in-line connectors.
y Press the switch and the status LEDs will inform you of the error
details.
y Is the SD card inserted correctly?
3 If there is no change after the SD card is inserted correctly, format
the SD card or replace it with a new one.
y Is the in-line connector for the front camera disconnected?
3 Check the connections of the in-line connectors. (see p. 1 4)
y Is the in-line connector for the rear camera disconnected?
3 Check the connections of the in-line connectors. (see p. 1 4)
y Is the in-line connector for the camera cable disconnected?
3 Check the connections of the in-line connectors. (see p. 1 4)
y Is the in-line connector for the GPS device disconnected?
3 Check the connections of the in-line connectors. (see p. 1 4)
y The unit is hot. Turn off image stabilization and temporarily reduce the
frame rate to prevent heat from generating and continue recording.
Stop recording if the temperature does not drop.
y Is the in-line connector for the switch disconnected?
3 Check the connections of the in-line connectors. (see p. 1 4)
y Is it too hot to touch?
3 It will heat up during use. Stop use immediately if it is too hot to
touch and contact the office listed in this manual.
y Is the top of the GPS antenna covered by metal or something with a
metal coating?
3 Remove the item covering it. Or move the GPS antenna to a
location where nothing will cover it. If the issue is not resolved, use
a dedicated cell phone app to synchronize the time.
20
Cause / Solution