Full Gauge TI-07Ri Manual Del Usuario página 11

IMPORTANT
According to the chapters from the IEC60364 standard:
1: Install protectors against over voltage on power supply.
2: Sensor cables and computer signals can be together, however not at the same place where power
supply and load wires pass for
For more information contact our application eng. department through e-mail
support@ fullgauge.com or dial +55 51 3475.3308.
Contact suppresor connection diagram
A1
A2
A1 e A2 are the
contactor coils.
Diagram for suppresor installation
for direct drive load inputs
Load
11
For direct activation the maximum
specified current should be taken
into consideration.