Publicidad
Idiomas disponibles
Idiomas disponibles
Description
Stainless steel adapter kit for installing a VERDEdri warm-air hand dryer using top-entry surface-
mounted conduit.
General Specifications
Material: AISI 304 Stainless Steel
Finish: Brushed
Dimensions W x H x D: 13-5/8" X 15-15/16" X 1-3/16" (34.6cm X 40.5cm X 3cm)
Weight: 4.8 lbs (2.2 Kg)
General Safety Information
DANGER
Failure to properly ground this unit could result in severe electrical shock and/or death.
•
The hand dryer must be properly grounded for safe operation. An identified ground connection
point is supplied on the hand dryer's wall base.
•
Follow the mounting height recommendations in Table 1.
Unpacking
1. Remove all packing material. Recycling is recommended.
2. Carefully remove the wall box from the shipping carton.
3. Inspect for any damage that may have occurred during transit. If the wall box is damaged,
promptly inform the dealer where you purchased it.
Installation
A. Mounting the Wall Box - Refer to Fig. 1 "Parts List and Installation Diagram
1. Place the adapter on the wall at the desired location, having the lower edge of the box at the
following heights from the floor. (See Table 1). Mark locations for the mounting bolt holes on the
wall.
2. Mount adapter to the wall using No. 10(3/16"), No. 12 or ¼" pan-head screws. (Not provided)
IMPORTANT
Head height of fastener should not exceed .175" (4.5mm) to ensure proper
clearance for dryer mounting. Use the appropriate fastener type for your
installation (hollow wall anchors for block or drywall, self-tapping for stud wall).
CAUTION
Improper mounting could result in personal injury or property damage. On a stud
wall, one side of the adapter plate should be mounted to an existing stud.
3. Run conduit from distribution panel to adapter. To limit voltage drop for efficient operation use
AWG 14 wire or larger as required by local electrical code.
IMPORTANT
Consult local and general regulations before performing dryer installation. Ensure
the electrical network is not overloaded. Always connect to a branch circuit with
circuit breaker or fuse protection with an electrical rating greater than the model
hand dryer's rated amperage shown in Table 1 - Electrical Specifications in
accordance with the required electrical codes such as NEC (National Electrical
Code) and/or CEC (Canadian Electrical Code).
1
Publicidad
