Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PicoScope USB Oscilloscope
WARNING
Unless specifically stated in the product User's Guide, PicoScope oscilloscopes are
not designed to measure hazardous live signals as defined by EN 61010. To prevent
electric shock, do not attempt to measure voltages outside of the limits shown in the
table above or the specified full scale measurement range, whichever is lower.
WARNING
To prevent injury or death, the oscilloscope must not be directly connected to the
mains (line power). To measure mains voltages, use a differential isolating probe
specifically rated for mains use, such as the TA041 listed on the Pico website.
CAUTION
Exceeding the overvoltage protection range on any connector can cause permanent
damage to the oscilloscope and other connected equipment.
CAUTION
When using the PicoScope 4224 IEPE oscilloscope, to prevent damage ensure that no
voltage is present when selecting IEPE interface mode, and no voltage is applied when
in use.
1.2.3
Grounding
WARNING
The oscilloscope's ground connection through the USB cable is for measurement
purposes only. The oscilloscope does not have a protective safety ground.
WARNING
Never connect the ground input (chassis) to any electrical power source. To prevent
personal injury or death, use a voltmeter to check that there is no significant AC or DC
voltage between the oscilloscope ground and the point to which you intend to connect
it.
CAUTION
Applying a voltage to the ground input is likely to cause permanent damage to the
oscilloscope, the attached computer, and other equipment.
CAUTION
To prevent measurement errors caused by poor grounding, always use the high-quality
USB cable supplied with the oscilloscope.
2
1.2.4
PicoScope models
PicoScope 6000 Series
PicoScope 5000 A and B Series*
PicoScope 3000 Series
(selected models)
* Powering these oscilloscopes by USB only may result in reduced functionality. Refer to the
PicoScope 5000 A and B Series User's Guide for further information.
1.2.5
Temperature
Humidity
Altitude
Pollution degree
Some PicoScope models have enhanced environmental specifications. Refer to the oscilloscope
User's Guide for further information.
Copyright © 2006–2018 Pico Technology Ltd. All rights reserved.
External connections
WARNING
To prevent injury or death, where applicable use only the power cord and adaptor
supplied with the product. These are approved for the voltage and plug configuration in
your country.
Note: not all oscilloscopes require an external power supply.
Voltage
Environment
WARNING
To prevent injury or death, do not use in wet or damp conditions, or near explosive gas
or vapor.
CAUTION
To prevent damage, always use and store your oscilloscope in appropriate
environments.
Storage
–20 °C to +60 °C
5% to 95% RH
(non-condensing)
Quick Start Guide
DC power input
Current
Power
12 V
4 A pk
48 W
5 V
1.5 A pk
7.5 W
5 V
1.2 A pk
6 W
Operating
Quoted accuracy
0 °C to 40 °C
20 °C to 30 °C
5% to 80% RH
(non-condensing)
2000 m (maximum)
2 (maximum)
DO115-19
Publicidad
Tabla de contenido
