Publicidad
Idiomas disponibles
Idiomas disponibles
Installation Instructions – PORLWTPD1
Installation Bracket
1.
Remove Enlighted Portfolio Accessory from emergency
bracket by unscrewing 2 #6 screws.
2.
Line up the holes in the Accessory with the holes in
the already assembled Emergency Battery Bracket.
3.
Pass the #6 screws from Step 1 through the holes in
the battery and bracket and screw into the PEM nuts in
the cover plate. (See Figure 6).
4.
The corresponding smart sensor (SU-3E-00) should be
mounted in the ceiling:
a.
To mount the sensor through a ceiling tile, thread
the spring arms around the sensor and insert the
sensor through a 15/16th inch hole in the tile.
5.
Connect sensor cable to control unit on the Enlighted
Accessory. Connect other end to ceiling mounted
sensor. (See Figure 3 Previously shown).
6.
Flex conduit from Enlighted Accessory should be
inserted into an available Knockout on the plaster frame
j-box. (See Figure 4 Previously shown).
7 .
Refer to Wiring Instruction and Diagram from the
Previous Section.
4
COOPER LIGHTING SOLUTIONS IL520007EN
#6 Screws
Figurt 6
Installation instructions
Publicidad
