Raven 2.0 Guía De Operación

SECTION CONTROL REMOTE 2.0
OPERATION GUIDE
Remote Overview
Off
LED
Left
Basic Operation
• Turn the pump on/off by entering "00" then pressing on or
off. Example: /
To turn sections/nozzles on, either:
• Press to turn all the sections/nozzles on.
• Enter the section/nozzle number and press on.
Example:
• Press or with all sections/nozzles off.
To turn sections/nozzles off, either:
• Press to turn all the nozzles off.
• Enter the section/nozzle number and press off.
Example:
On
Right
016-0171-685MTL Rev. B
Getting Started
• Install two AA batteries.
Note:
Use Lithium batteries for optimal performance.
• To turn the remote on, press
• Enter the four digit code displayed on the UT, then press
.Example:
• Flashing green LED indicates a successful connection.
• Once paired, passcodes are stored on the remote and do
not need to be reentered.
• To turn the remote off, press and hold
Preparing the Machine
• The machine must be stationary.
• Select the wireless control checkbox on the UT (1).
• Enable the master switch and section switches.
• Choose between section or nozzle control mode on the UT
(2).
LED Status Indicator
• 5Hz - Scanning for ECUs.
• 1Hz - Connected - waiting for passcode.
• 1Hz - Connected - passcode entered successfully.
• 1Hz - Low Battery.
E34564 1/2020
.
for three seconds.
1
2