Publicidad
Idiomas disponibles
Idiomas disponibles
Change remote control battery
When the remote control does not feedback with acoustic or visual
behavior after pressing the button, change the battery (CR2032).
For changing the battery use a coin to open the battery compartment.
Turn the cover on the backside of the remote control left to open and
right to close. Insert the battery. After inserting you should see the
"plus" pole of the battery. Now close the compartment.
Troubleshooting
First remove the small plastic strip on the back of the remote
control.
The device could not be paired
If pairing fails for the first 5 seconds, unplug the device from the
cigarette lighter socket, plug it in again and press the button on the
remote control to pair.
Note: During the first 5 seconds right after plugging the device into
the cigarette lighter socket, it is always possible to pair a remote
control.
Product Video
Either scan this QR code with your Smartphone, or use this
YouTube link:
https://www.youtube.com/watch?v=WCX-UDRkdP4
FCC Warning:
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to
radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Caution: Any changes or modifications to this device not explicitly approved by manufacturer could void your authority
to operate this equipment.
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device
may not cause harmful interference, and (2) this device must accept any interference received, including interference that
may cause undesired operation.
The device has been evaluated to meet general RF exposure requirement. The device can be used in portable exposure
condition without restriction.
Publicidad
