Tabla de contenido
Publicidad
20
STUDIO 50USB/MEDIA 40USB
STUDIO 50USB/MEDIA 40USB Getting started
Step 3: Getting
(EN)
started
Place the monitor speakers at head level,
unobstructed and at equal distances to
the left and right of your
listening position.
Connect the included power cable to the
right monitor. Connect the other end to a
mains outlet properly configured for your
particular model. DO NOT turn the power on yet.
If possible, connect the right monitor and the other
audio equipment in the system to the same outlet to
avoid ground loops.
Connect the audio source to the inputs of
the right monitor. Balanced XLR or TRS
connections are preferable, if your mixer
or equipment has balanced outputs. You may also
connect the audio outputs from a computer using
the type B USB connector.
Connect the supplied speaker cable from
the right monitor's speaker output
connector to the left monitor's speaker
input connector.
MEDIA 40USB: Turn the VOLUME knob
on the front of the right monitor to the
fully-down position.
STUDIO 50USB: Turn the INPUT TRIM knob on
the rear panel of the right monitor to the center
(0 dB) position.
Turn on your mixer, computer, or other
audio source, and make sure the volume
is turned down.
Turn on the power on the right monitor
by flipping the rear panel power switch.
Start playing your audio source and
slowly increase the volume until you
reach a comfortable listening level.
MEDIA 40USB: Adjust the VOLUME knob on the
front of the right monitor.
STUDIO 50USB: Adjust the INPUT TRIM knob on the
back of the right monitor if required, or leave it at
the center (0 dB) position.
Publicidad
Tabla de contenido
