Motor Safetyfilterchanging; Hood And Tool Storagecover Installation - Sears Kenmore 116.21714 Manual De Uso

I
MOTOR SAFETYFILTERCHANGING
I
The motor safety filter must be replaced when dirty. It should be replaced regularly
depending on use conditions. The motor safety filter CANNOT be washed as it will lose its
dust trapping ability.
NOTE: Use replacement motor safety filter STYLE CF-1 or 8175084, see part number detail in
REPLACEMENT PARTS (page 5).
iiiiil,,i ii,i i
IEiectrlcal Shock Hazard
Turn off and unplug vacuum cleaner from
electrical outlet. Do not operate the
vacuum cleaner without the motor safely
filter. Be sure the filter is dry and properly
installed to prevent motor failure and!or
electrical shock.
iii i
1. Remove the dust bag as outlined in the
DUST BAG CHANGING section (page 21).
2. Lift the rubber retainer and pull out motor
safety filter as shown.
3. Replace the motor safety filter, white
side facing toward dust bag, by sliding it
back into place under the ribs In the bag
cavity. Tuck motor safety filter in so that it
fits completely under the rubber retainer.
4. Replace the dust bog as outlined in the
DUST BAG CHANGING section (page 21).
HOOD AND TOOL STORAGECOVER INSTALLATION j
It is normal for the canister hood and tool
storage cover to come off when opened
further than needed. Line up the hinge slots,
insert the hinges into the slots, and close
the hood and tool storage cover to
reinstall.
"_CAUTION
Never open canister hood with the tool
storage cover open. This will help to
prevent damage from occurring to the
canlster,htod andlor tool storage cover.
22