Publicidad
Introduction
This installation instruction covers parts or accessories
manufactured or marketed by Volvo Penta and used in
the specified application and for the intended purpose
recommended by Volvo Penta. Any use other than
those specified may give unpredictable results and
result in equipment failure or personal injury.
Proper preparation is extremely helpful for efficient
service work. A clean work area at the start of the job
will minimize tools and parts becoming misplaced.
Obtain tools, instruments and parts needed for the job
before work is started. Interrupting a job to locate
special tools or repair kits is a needless delay.
When following these instructions the installer must
adhere to all U.S. Coast Guard Safety Regulations and
ABYC Recommendations and Standards, or other
regional regulation that may be in effect.
Service Policy
Whether within or following the warranty period, Volvo
Penta has a constant interest in our products.
It is Volvo Penta's policy to provide dealers with service
knowledge so they can give professional service
demanded by today's consumer. Volvo Penta Service
Schools, frequent mailing of Service Bulletins, Letters
and Promotions, Special Tools and these instructions
represent Volvo Penta's efforts in giving consumers the
best and most prompt service possible. If a service
question does not appear to be answered in these
instructions, you are invited to call or write to the Volvo
Penta Service Department for additional help. Always
be sure to give complete information, including engine
model and serial number.
Be sure you are familiar with Volvo Penta's Warranty. If
you have any questions, call or write the Volvo Penta
Service Department. If other than genuine Volvo Penta
parts and components are used, Volvo Penta may
refuse subsequent warranty claims involving that
engine.
DANGER! Failure to comply with a danger symbol will result in death or serious
injury.
WARNING! Failure to comply with a warning may result in death or serious
injury.
CAUTION! Failure to comply with a caution may result in injury.
NOTICE! Special attention should be used to prevent incorrect assembly or disassembly.
Failure to comply with a notice may result in equipment failure or damage.
When a brand-name product or specific tool is
specified, another item may be used. However, the
substitute must have equivalent characteristics,
including type, strength, and material. It is your
responsibility to determine if incorrect substitution could
result in product malfunction and personal injury to
anyone. To avoid hazards, equivalent products which
are used must meet all U.S. Coast Guard Safety
Regulations and ABYC standards.
References, Illustrations and Specifications
Volvo Penta reserves the right to make changes at
anytime, without notice, to specifications, models, and
procedures. Also, the right to change any specifications
or parts at any time without incurring any obligation to
equip same models manufactured prior to date of such
change. All information, photographs, illustrations, and
specifications, contained in these instructions are
based on the latest information available at the time of
printing.
Photographs and illustrations used in this instruction
may not depict actual models or equipment. The
continuing accuracy of this installation instruction
cannot be guaranteed.
Use the general torque specification for all fasteners
unless otherwise specified in the instructions.
Important Safety Notices
Carefully observe the safety alert symbols below for
dangers, warnings, and cautions. They alert installers
and operators of possible dangers or important
information contained in this manual.
Warnings alone do not eliminate hazards. They are
no substitute for professional workmanship and
proper installation.
1
Publicidad
