Laney AH-FREESTYLE Manual Del Usuario página 5

REAR
DC Power Supply: Your AH-Freestyle comes supplied with a 12V DC Power Supply, this is easily fitted
between the mains outlet and the amp. When using the amp with the power supply a few precautions should
be followed:
5.5 x 2.1 mm
1). Only use the DC Power supply that is supplied by the manufacturer. The use of other DC Power Supplies
may cause damage or other problems.
2). Turn the power switch to OFF and disconnect any other attached devices, before plugging in and turning
12V DC 500mA
Power Consumption 6W
ON the DC Power Supply.
3). When the DC Plug is connected to the socket, the battery compartment is isolated from the unit. Both
FRONT
the DC Power Supply and the battery tray are independent of each other.
4). Although no harm will come to the batteries if left in place whilst the DC Power supply is being used, it
is recommended that they be removed. Use either one power source or the other.
Batteries: The use of a DC Power Supply is recommended as the units main power source, however,
PHONES/
should you prefer to use batteries, use only Alkaline type (LR6).
LINE OUT
Used continuously the batteries will last for approximately 40 hours. (This will vary greatly with the actual
POWER
conditions of use).
As the batteries run down, the power indicator on the fascia panel will become dim when the battery power
is too low. Replace the batteries or revert to the DC Power Supply.
Fitting Batteries: When installing or replacing batteries, always turn the power switch to the OFF position and disconnect
any other devices you have may have connected. This prevents damage to your speaker and/or other devices. Follow the photo
sequence to fit a set of batteries.
1). Turn the amplifier around to access the battery tray that is located on the back the chassis, place the amp on a piece of felt
or cloth to avoid damage.
2). Push the catch to release, then lift out the lid of the battery tray and insert 6 AA batteries, ensure that the orientation is
correct to the legend on the tray.
3). When closing the lid of the battery tray, insert the tabs opposite the catch first, then push the lid down until a click is heard.
6