Dubbing - Teac W-1200 Manual Del Usuario

TAPE 1 can be dubbed to TAPE 2.
1 Load a cassette tape for playback into the
TAPE 1 compartment and a cassette tape for
recording into the TAPE 2 compartment.
2 Press the DUB START (dubbing start) button to
start dubbing.
This will start dubbing at normal speed.
During dubbing, the dubbing (NORM DUB) indicator lights on
the display.
o To start dubbing using the remote control, press both DUB
START (dubbing start) buttons on it at the same time.
o The DUB START (dubbing start) button does not work imme-
diately after the tape is fast-forwarded or rewound to the
end. Wait for 5 seconds or more before pressing the button.
When TAPE 1 playback stops, dubbing also stops automatically.
Pausing dubbing
Press the TAPE 2 PAUSE button to pause dubbing. When paused,
TAPE 1 will continue playing, but TAPE 2 will not record.
Press it again to resume dubbing.
Stopping dubbing before playback ends
Press the TAPE 1 or TAPE 2 stop (8) button.

Dubbing

o The TAPE 2 REC MUTE (record muting) can be used to record
silences (page 20) even while dubbing. (The TAPE 1 REC MUTE
(record muting) button cannot be used.)
Erasing unnecessary parts and creating spaces between songs is
possible while dubbing.
o The pitch control function is disabled while dubbing.
o The recording level cannot be adjusted while dubbing.
o Use the same procedures to dub the other side of the tape
as necessary.
o To disable mic mixing, do not connect a mic to the MIC
connector on the front of the unit. Dubbing when a mic is
connected will result in a slightly lower recording level.
23