Publicidad
Idiomas disponibles
Idiomas disponibles
General description
A
Shaving unit with three shaving heads. Each shaving
head consists of a guard and a cutter.
B
Green pilot light. Illuminates whilst the shaver is
connected to the mains supply (for charging or shaving
directly from the mains).
C
On/Off switch. The shaver is prevented from being
switched on accidentally by the locking device
incorporated in the switch.
- On: keep the locking knob on the switch pressed-in
and slide the switch upwards.
- Off: slide the switch downwards.
D
Mains cord. Using the mains cord you can connect the
shaver to any mains voltage between 100 and 240 Volts
AC (for charging and shaving).
E
Connector. When using the mains cord insert the small
plug firmly into the connector up to the indication mark.
F
Trimmer. The trimmer can be switched on whilst the
motor is running.
- Switch on by moving the slide (f) upwards.
- Switch off by moving the slide downwards.
- Brush the trimmer clean after use.
G
Brush. Refer to section "Maintenance and cleaning" for
correct usage.
H
Protective cap. Keep the protective cap on the shaver
when not in use.
Shaving tips
• The best results are obtained if the skin is dry. So
preferably shave before washing or some time afterwards.
• If required, apply a preshave lotion. This can be
particularly helpful if the climate is warm and humid.
• The Philishave system gives you a quick, close and
comfortable shave. Just move the shaving unit quickly
over the skin.
• For the best results stretch the skin to bring the hairs into
an upright position.
Then move the shaving unit against the direction of the
growth of the hairs.
(fig. 1, page 3)
for a close, quick and comfortable shave
5
Publicidad
