Publicidad
Idiomas disponibles
Idiomas disponibles
NOTE: Use to cut EPS, Polyethylene and
Polypropylene foams. DO NOT use to cut
Polyurethane foam or rubber.
1.
Plug in to a standard 110V outlet.
2. Set temperature control knob to midrange setting.
(See Figure 2)
Figure 2
3. Place blade against the edge of the foam and
squeeze the trigger. Blade will heat up to optimal
temperature within 10-20 seconds.
1.
If foam builds up on knife after use, unplug unit and
let cool completely.
2. Disassemble blade from knife.
3. Spray with carburetor/starter fluid and gently scrub
the blade using a soft wire brush or steel wool until
buildup is removed.
OPERATING ISSUE
Knife will not turn on.
Foam build-up on knife.
Knife stops working during use.
Excessive smoking during cutting.
PAGE 2 OF 6
OPERATION INSTRUCTIONS
BLADE CLEANING INSTRUCTIONS
TROUBLESHOOTING
CAUSES
No power to knife.
Blade not installed properly.
Foam residue forms after
repeated uses.
Knife overheated.
Using knife longer than 10
minutes at a time.
Cutting foam too slowly.
Blade too hot.
1-800-295-5510
uline.com
NOTE: If excessive smoke develops, you are
cutting too slowly or the blade is too hot.
CAUTION! Keep hot blades away from skin,
clothing and other flammable materials.
4. Once smoke starts to appear during cutting, release
the trigger and keep moving the knife through the
foam.
NOTE: The entire blade should be immersed in
the foam while cutting.
CAUTION! Do not tape trigger down or force
trigger into the on position in any way.
5. As cutting speed slows due to greater resistance,
squeeze the trigger again for 10-20 seconds.
NOTE: Knife is designed for use in 10-minute
intervals. Allow knife to cool down between
intervals to prevent overheating.
6. Release trigger approximately 1-2" inches prior to
completion of the cut to prevent buildup on the
knife.
CAUTION! In the event foam builds up on the
knife, DO NOT ATTEMPT TO BURN OFF.
RECOMMENDATIONS
Verify knife is plugged into live, standard 110V outlet.
Make sure blade is installed correctly and tightened.
See "Blade Installation" instructions.
Follow "Blade Cleaning Instructions."
Let knife cool and restart.
Make sure knife is not forced on.
Release trigger.
Let knife cool.
Restart unit.
0521 IH-1079
Publicidad
