Anjou TT-AD012 Manual Del Usuario página 10

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 16
Set the Light Mode and Adjust the Light Brightness
1. Press the Light Button once to enter automatic color carousel
mode where 7 colors will be cycled through.
2. Press again to stay on the current color. Keep pressing to cycle
through different colors.
3. Press the Light Button twice to dim the light to 50% brightness.
Press another twice to resume 100% brightness.
4. Press and hold the Light Button for 2 seconds to turn off the light.
Memory Function If power is not disconnected, the diffuser will
remember the last light brightness setting when switched on again.
Low Water Protection
The diffuser will turn off automatically when water inside the tank has
been depleted. Once water is added back into the tank, the diffuser
will resume standby mode.
How to Clean
IMPORTANT!
Please unplug the unit before cleaning!
Regular Cleaning
1) Empty the tank from the water outlet.
2) Add 3-5g (approx. one teaspoon, based on scale of the residues)
baking soda / NaHCO3 to the tank.
3) Fill the tank halfway full with warm water (200-250ml / 6.76-8.45fl
oz, 50°C / 122°F), stir it to fully dissolve.
4) Soak for 3-5mins, wipe down the tank and tank cover using a small
brush or soft cloth with baking soda solution. (For better cleaning,
remove the muting cover and wipe it down thoroughly).
5) Drain the solution and rinse the tank under tap water.
6) Rub the inside and outside dry with a dry towel or clean cloth.
7) Wipe off the soda residues if any.
Deep Cleaning
You are recommended to deep clean your diffuser once a month or
when the mist output is low due to grime build-up.
1) Empty the tank from the water outlet.
2) Add 2-3 teaspoons of baking soda / NaHCO3, or 2-3 slices of fresh
lemon to the tank.
3) Fill the tank halfway full with warm water (200-250ml / 6.76-8.45fl
oz, 50°C / 122°F), stir it to fully dissolve.
4) Soak for about half an hour.
5) Thoroughly clean the grime at the bottom and atomizer (slot at the
center) of the tank with a small brush.
6) Wipe down tank cover using a small brush or soft cloth with baking
soda solution. (For better cleaning, remove the muting cover and
wipe it down thoroughly).
7) Drain the solution and rinse the tank under tap water.
8) Wipe off the soda residues if any.
9) Rub the inside and outside dry with a dry towel or clean cloth.
Notes:
1) You may use dishwashing detergent when baking soda is
unavailable. But it works better for oil removing instead of odor
and mineral buildup.
2) Do not rinse the base directly with water; try to avoid wetting the
buttons, light holes, air inlets and underneath to avoid short circuit.
3) It is not recommended to clean the unit with white vinegar since
its direct and indirect contact with the atomizer will damage it
permanently.
03/04

Publicidad

Tabla de contenido
loading

Productos relacionados para Anjou TT-AD012

Tabla de contenido