Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
Tools and Parts
F1
5/16" Allen-head
Phillips-head screw
bolt (16)
Gather the required tools and parts before starting installation.
Tools Needed:
1/2" Wrench
■
Phillips screwdriver
■
Tool Supplied:
Allen wrench
■
Part Supplied:
Key
■
Cabinet Use Requirements
Intended for use in a garage.
■
Maximum weight limit is 50 lbs (22.7 kg) for each shelf.
■
Maximum weight limit is 300 lbs (136 kg) for the cabinet.
■
Unpack the Cabinet
1. Remove and verify the contents. Contents include an Allen
wrench, a key, and the parts and fasteners shown in "Parts."
2. Dispose of/recycle all packaging materials.
ASSEMBLY INSTRUCTIONS
F3c
F14
Hex head bolt (16)
(32)
Level
■
Assemble Cabinet
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet.
Failure to do so can result in back or other injury.
IMPORTANT: Two people may be required to complete the
assembly. As you assemble the cabinet frame, make sure the
edges with the loops are facing up. The cabinet top (P2) is
intentionally designed so that the tabs will match with the loops
on the sides only when it is positioned correctly. If the tabs on the
cabinet top do not match up with the loops on the side panel (P1),
turn the cabinet top around.
1a.
Install Cabinet
P1
P3
P1
P3
Place side panel (P1) on a flat, firm surface so that the edge with
the loops is facing up as shown. Align the tabs in the cabinet top
(P2) with the loops in the cabinet side (P1). Slide the cabinet top
between the edges of side panel.
NOTE: Make sure each tab is inserted fully behind the loop.
Align the two holes in each corner. Using Allen-head bolts (F1),
fasten the side panel (P1) to the top (P2) as shown. Do not tighten
completely. Repeat steps 2 and 3 for the other cabinet side (P1).
With the smooth side toward the cabinet interior, align the four
tabs in the cabinet bottom (P3) with the loops in the cabinet sides
(P1). Slide the cabinet bottom between the edges of side panels.
NOTE: Make sure each tab is fully inserted behind the loop. Align
the two holes in each corner. Using Allen-head bolts (F1), fasten
the side panels (P1) to the bottom (P3) as shown. Do not tighten
completely.
P2
P1
P1
P3
3
Publicidad
Tabla de contenido
