Assembling Your Nebulizer - MABIS CompXP 40-136-000 Manual Del Usuario

2) Following general safety precautions, plug
the adapter into an automobile DC outlet.
3) Proceed to "Assembling and Operating Your
Nebulizer" instructions.
Using the Rechargeable Battery Pack,
Your Compressor Nebulizer can operate with
the use of a rechargeable battery when AC
power is not available. The life of the battery is
approximately two years; however, battery life
will vary depending on usage, storage and
charging conditions.
To charge the battery,
1) Insert the AC adapter plug into the
receptacle of the battery pack, located on
the top of the battery
pack, see Fig 3.
2) Following general safe-
ty precautions, plug
the adapter into a
standard AC outlet.
Approximate charging
times:
1st time use: 24 hours
Thereafter: 4-12 hours
To use the battery,
1) Expose the battery
terminal on the
bottom of the
compressor by
removing the rubber
base, Fig. 4.
2) Attach the
compressor and
battery pack making
sure that the battery
terminals meet,
Fig. 5. The two
components should
snap together into
place. Check that the
compressor and
battery pack are securely connected.
NOTE: Press the POWER button. A green
light will illuminate above the POWER
button to indicate a charged battery. A red
light indicates that the battery needs to be
charged.
3) Proceed to "Assembling and Operating Your
Nebulizer" instructions.
To unlock the battery,
1) While holding both the compressor and bat-
2) Reattach the rubber
NOTE: When the battery
pack is not in use it is
important to keep the
rubber base attached at all
times. The rubber base will
help stabilize the unit on a
flat surface and protect the
battery terminal.

Assembling Your Nebulizer

Follow the cleaning instructions in this
guidebook under "Cleaning Technique" prior to
using your nebulizer for the first time or after it
has been stored for an extended period of time.
REMEMBER: Always disconnect the unit from
the electrical outlet and make sure the POWER
Fig. 3
switch has been pressed to "off" before
leaning, assembling and before or after each
use.
1) Gently twist and pull straight
Fig. 4
2) Make sure that the purple
3) Add the prescribed amount
Fig. 5
4) Reassemble the Nebulizer by carefully
5) Place the compressor on a solid, flat dry
5
tery pack, press the rectangular-shaped but-
ton located on the front of the battery pack.
The components should release, Fig. 6.
base to the bottom of
the compressor.
up on the lid of the
Nebulizer to separate into
two parts (medicine cup and
cover).
jet is properly installed
inside the medicine cup.
(The stem inside the
medicine cup inserts into
the tube of the purple jet),
Fig. 7.
of medication to the
medication cup, Fig. 8.
wisting the medicine cup and cover
together. Make sure that the two parts fit
securely.
surface. Insert the nebulizer into the unit
making sure that the stem of the medicine
cup inserts securely into the rubber stem.
Fig. 6
Fig. 7
Fig. 8