Electric Wiring Work; General Instructions; Wiring Connection - LG PM12EP Guia De Inicio Rapido

INSTALLATION PLACES
- There should not be any heat source or
steam near the unit.
- There should not be any obstacles to prevent
the air circulation.
- A place where air circulation in the room will
be good.
- A place where drainage can be easily ob-
tained.
- A place where noise prevention is taken into
consideration.
- Do not install the unit near the door way.
- Ensure the spaces indicated by arrows from
the wall, ceiling, or other obstacles.
- The indoor unit must keep the maintenance
space.

ELECTRIC WIRING WORK

General instructions

- All field supplied parts and materials, electric
works must conform to local codes. Use
copper wire only.
- Follow the "WIRING DIAGRAM" attached to
the unit body to wire the outdoor unit, indoor
units and the remote controller.
- All wiring must be performed by an
authorized electrician

Wiring Connection

Connect the wires to the terminals on the
control board individually according to the out-
door unit connection.
Ensure that the color of the wires of outdoor
unit and the terminal No. are the same as
those of indoor unit respectively
1(L) 2(N) 3(C)
Connected to outdoor unit
or B.D. unit.
INSTALLATION MANUAL
More than 100
B
Type
Wall mounted
CAUTION
!
• The connecting cable connected to the
indoor and outdoor unit should be com-
plied with the following specifications
(Rubber insulation, type H05RN-F ap-
proved by HAR or SAA).
• If the supply cord is damaged, it must
be replaced by a special cord or assem-
bly available from the manufacturer of
its service agent.
Using the remote controller
(Optional)
You can operate the air conditioner more con-
veniently with the remote controller.
You will find the buttons for the additional
functions under the cover of the remote con-
trol.
7
More than 200
A
More than 100
B
(Unit : mm)
A B
200 100
NORMAL
CROSS-SECTIONAL
AREA 1.0mm
2