Parts List - Triton WRA001 Montaje

PARTS LIST

ASSEMBLY
The bottom of the Upright (B) has a small screw
hole 13mm from the end. Tighten a Screw (A) into
this hole, then slide a Rack (C) down the upright
until it locates onto the screw. The notched side of
the rack (circled) must face down.
Tighten a screw into the next hole up, then slide
another rack into position. Continue this until all
racks are fitted. For alternative rack positions drill
additional 2.5mm holes. Repeat steps 1 and 2 for
the remaining upright and racks.
Find a solid mounting location and ensure you are
fixing to structural supports when mounting. Space
the uprights around 1200mm to 1800mm (4' to
6') apart. For storage of very long materials use
additional WoodRacks.
GB
Fit the Spacers (D) over the mounting holes,
as shown, and fasten to the wall using the
recommended fasteners (not supplied) as outlined
in Steps 4, 5 or 6.
Assembly
2
A. Screws (12)
D. Spacers (6)
Fig: 1
Fig: 2
Fig: 3
B. Uprights (2)
C. Racks (12)
Mounting to Masonry: Use 6mm masonry
anchors suitable for fixing 30-40mm thickness.
Storing small items: Construct a simple shelf for
any of the levels as shown.
Mounting to timber: Use 5.5mm hex head wood
screws, at least 65mm. Where required install
vertical supports.
Outside use: For weather protection staple
horizontal battens to a plastic sheet, then fix the
top batten above the racks.
Mounting to a steel shed: Ensure racks are
mounted to structural framework. If steel use a
min. 6mm bolts. If wood, refer to Fig.5. Install floor
to roof verticals if required-secure to the steel
sheet with fasteners every 300mm
Fig: 4
Fig: 5
Fig: 6