ESAB Eye-Tech 9-13 Manual De Instrucciones página 17

Shade cartridge does not darken or flickers
• Sensors are soiled or obstructed:
sensor bar tilted
• Front cover lens soiled or damaged.
• Welding current too low; remove sen-
sor bar, if necessary.
Slow response
• Operating temperature too low (do
not use at temperatures below –10°C;
14°F).
Poor vision
• Protective lenses and/or shade car-
tridge soiled.
• Insufficient ambient light
• Shade level incorrectly set.
Welding mask slips
• Headband not adjusted properly
(must be lowered)
You must not use the shade cartridge
if the fault cannot be remedied. Get in
touch with your dealer.
Technical Data
(All data are subject to change without
prior notice)
Field of vision: 98 x 38 mm
(3.86" x 1.50")
Light transmittance:
Permanent ultraviolet and infrared
protection min. shade 14
When activated:
Infinitely variable manual adjustment of
shade levels DIN 9-13
When not activated:
Shade level DIN 4
Response:
light to dark:
0.4 ms at room temperature
dark to light:
• Position slow
0,3 - 0,6s
• Position fast
0,1 - 0,35s
Operating temperature:
–10°C to +70°C (14°F to 158°F)
Power supply:
Solar cells
Water-resistant:
Waterproof in accordance with IP 67
(test duration 30 min. depth 1 m/3,28'
(except potentiometer))
Mask material:
High-impact plastic
Weight:
Mask, compl. 490 g (17.3 oz.)
Cartridge 120 g (4.2 oz.)
G
Hold front lens frame at bottom edge
and pull up.
Insert front cover lens into frame and
snap the front lens frame into place first
at the top and then at the bottom;
press firmly into place.
Use only original ESAB front cover len-
ses!
GB
i