Declaration Of Conformity; Industry Canada (Ic) - HP ProCurve Manual Del Usuario

United States
Federal Communications Commission (FCC)
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to
Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a residential installation.
This equipment generates, uses, and can radiate radio frequency energy. If not installed and used in accordance
with the instructions, it may cause harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try and correct the interference by one or more
of the following measures:
●
Reorient or relocate the receiving antenna.
●
Increase the distance between the equipment and the receiver.
●
Connect the equipment to an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.

Declaration of Conformity

Products marked with the FCC logo comply with Part 15 of FCC Rules. Operation of the device is
subject to the following two conditions (1) This device may not cause harmful interference, and (2)
this device must accept any interference that may cause undesired operation.
Products that contain a radio transmitter are marked with FCC ID number and may also carry the FCC logo.
Caution: Exposure to Radio Frequency Radiation.
To comply with the FCC radio frequency exposure requirements, the following antenna installation and device
operating configurations must be satisfied:
1. For configurations using the integral antenna, the separation distance between the antenna(s) and any
person's body (including hands, wrists, feet and ankles) must be at least 2.5 cm (1 inch).
2. For configurations using an approved external antenna, the separation distance between the antenna
and any person's body (including hands, wrists, feet and ankles) must be at least 20 cm (8 inch).
The transmitter shall not be collocated with other transmitters or antennas.
Modifications
The FCC requires the user to be notified that any changes or modifications to this device that are not expressly
approved by the manufacturer may void the user's authority to operate the equipment.
Canada

Industry Canada (IC)

This device complies with the limits for a class B digital device and conforms to Industry Canada standard
ICES-003.
Products that contain a radio transmitter comply with Industry Canada standard RSS 210 and are labelled with
IC approval number.
ETL listed products conform to ANSI/UL STD.1950 certified to CAN/CSA STD C22.2 NO.950.
Cet appareil numérique de classe B est conforme à la norme ICES-003 de Industry Canada.
La radio sans fil de ce dispositif est conforme à la certification RSS 210 de Industry Canada et est étiquetée
avec un numéro d'approbation IC.
Les produits répertoriés ETL sont conformes à ANSI/UL STD.1950 certifiés selon la norme CAN/CSA STD C22.2
NO.950.
13