Automatic Filter Cleaning; Transport; Storage; Maintenance And Care - Würth ISS 35 Traducción Del Manual De Instrucciones De Servicio Original

Automatic filter cleaning

ISS 35-S automatic, ISS 55 automatic, ISS
55-S automatic only:
The appliance has an innovative filter cleaning sys-
tem that is particularly effective with fine dust. The
flat pleated filter is automatically cleaned every 15
seconds through an air jet (pulsating sound).
Note: Automatic filter dedusting is switched on at
the factory.
Note: The automatic filter dedusting function can
only be switched on/ off when the appliance is
switched on.
To switch off automatic filter cleaning:
–
 Activate the switch. Indicator lamp in the
switch goes off.
To switch on automatic filter cleaning:
–
 Press the switch again. Indicator lamp in the
switch glows green.
Turn off the appliance
 Switch off the appliance at the main switch.
 Pull out the mains plug.
After each operation
 Empty the container.
 Vacuum and wipe the appliance inside and
outside with a damp cloth.
Storing the Appliance
Illustration
 Store the suction hose and the mains cable as
shown in the illustration.
 Place the appliance in a dry room and secure
it from unauthorized use.

Transport

Caution
Risk of injury and damage! Observe the
weight of the appliance when you trans-
port it.
 Remove the suction pipe with the floor nozzle
from the holder. Hold the appliance at the han-
dle and at the suction pipe to transport it.
16
 When transporting in vehicles, secure the ap-
pliance according to the guidelines from slip-
ping and tipping over.

Storage

Caution
Risk of injury and damage! Note the
weight of the appliance in case of stor-
age.
This appliance must only be stored in interior
rooms.

Maintenance and care

Danger
First pull out the plug from the mains be-
fore carrying out any tasks on the ma-
chine.
Caution
Keep the device and the ventilation lou-
vres clean in order to be able to work
well and safely.
If the vacuum cleaner should fail inspite of thor-
–
ough manufacturing and testing procedures,
have the repair performed by a Würth master-
Service centre.
Please indicate the part number taken from the
–
type plate of the vacuum cleaner in case of
questions or spare parts orders.
Exchanging the flat pleated filter
 Open filter door.
 Replace the flat pleated filter.
 Close the filter door, it must lock into place.
Cleaning the electrodes
 Release and remove the suction head.
 Clean the electrodes with a brush.
 Insert and lock the suction head.
4