Rola Pick-Up-Rack Instrucciones De Instalación página 4

Please read all instructions carefully before assembly, installation and/or use of this product.
4
5
Mark
•
Remove crossbar from vertical supports. Remove adapter blocks from crossbars.
•
Measure to the distances "A", "B", "C" from pencil marks made in step shown above.
•
Using a small hack saw, cut the under cover to (2)length "A", (2)length "B", and (1)length "C.
•
Install "C" length under cover, then (2) M8 T-Bolts, then "B" length under covers, then (4) M10 T-bolts (2) per side with the (2) Adapter
blocks, then "A" lengths under covers as shown below. TIP: Align under cover with marks made in step above.
M10 T-Bolt
6
•
Place crossbars onto Vertical Supports and center crossbar side-to-side.
•
Align the Adapters and M10 T-Bolts with the Vertical Supports Flanges.
•
IMPORTANT NOTE: Ensure crossbar is sitting flat on the Vertical Support Flanges.
Cequent Performance Products, Inc.
Plymouth, MI 48170
Technical Service: (888) 521-0510
Mark
Mark
"A"
"B"
M8 T-Bolt
Bottom view of crossbar
Product Name:
Pick-Up-Rack™
Product Code:
•
End cap
Under cover
•
Place crossbar onto Vertical Supports and center side-to-side.
•
Be sure to align the Adapter Blocks with the Vertical Supports Flanges.
•
Mark with pencil the crossbar location on each side of Vertical Support
Flange and Corner Brace foot for under cover installation.
•
IMPORTANT NOTE: It is important to step 7 that you ensure crossbar is
sitting flat on the Vertical Support Flanges. If the crossbar does not sit
flat, the carriage bolt might spin inside crossbar while tightening.
Mark
"B"
"C"
Adapter
Page 4 of 7
59742
Remove end caps and under covers from
crossbars.
Unlocked
Mark
Mark
"A"
CORRECT
Vertical Supports Flanges
59742N Rev G 4-19-16
Locked
INCORRECT
Printed in China