Maintenance - SPARKY FSPE 110 Instrucciones De Uso

DUST SUCTION
Mount and press adapter 10 to the arch on the
base plate. In order to dismount the adapter,
RECOMMENDATIONS
When sawing metal, apply cooling liquid (water
or oil) on the line of cut. In case of sawing thin
metal sheets, tighten in advance the sheet on
a wooden support. Thus the cut edge will be
smoother.
Circular cutting is possible at minimum radius
100 mm and maximum thickness of the mate-
sible up to 50 mm thickness of the material.
ACCESSORIES TO BE USED WITH
THIS POWER TOOL
Blades with Bosch type shank shape, up to
1,5 mm shank gauge, for sawing wood, metal
and non-metal materials.

Maintenance

WARNING: Always ensure that
the tool is switched off and unplugged
before attempting to perform inspection or
maintenance.
BRUSH REPLACEMENT
This power tool is equipped with auto-stop
brushes. When the carbon brushes are worn
out, the machine switches itself off. In this case
both brushes must be replaced simultaneously
with genuine brushes at SPARKY service cen-
tre for warranty and post-warranty service.
GENERAL INSPECTION
Regularly inspect all fasteners and ensure
they are properly tightened. Should any of the
screws be loose, retighten it immediately to
avoid hazards.
If the replacement of the supply cord is neces-
sary, this has to be done by the manufacturer or
his agent in order to avoid a safety hazard.
EN 8
CLEANING
and its ventilation slots clean.
- Regularly check to see if any dust or foreign
matter has entered the ventilation slots and
the grills around the switches. Use a soft brush
and/or air jet to remove any accumulated dust.
Wear safety glasses to protect your eyes whilst
cleaning.
Exterior plastic parts may be cleaned with a
damp cloth and mild detergent if necessary.
WARNING: Never use alcohol, petrol
or other cleaning agent. Never use caustic
-
agents to clean plastic parts.
WARNING: Water must never come
into contact with the tool.
NOTE: Power tools are subject to accelerated
wear and possible premature failures when
The chips and grindings from these materials
are highly abrasive to bearings, brushes, com-
mutators, etc. It is not recommended to use the
tool on these materials for continuous opera-
tion. When sawing such materials it is extreme-
ly important to clean the power tool frequently
with compressed air.
IMPORTANT! To assure product safety and
reliability, repairs, maintenance and adjustment
(including brush inspection and replacement)
always using genuine replacement parts.
-