IMPORTANT:
Read these instructions carefully to familiarize yourself with
the appliance before connecting it to the gas bottle.Keep
these instructions for future reference.
This appliance works with B-250 butane gas bottle, according
to En417 standars.
To be used only in well ventilated locations to benefit from the
air supply combustion( Minimum ventilation required 5m3/h)
and avoid dangerous building up of unburnt gases (for the
appliances not fitted with a flame supervision device).
Keep young children away from the appliance.
WARNING
Remove the packed drip pan support from the top of the
stove.Turn it over into its ready position with the pan support
upwards.
Do not use the appliance if it is damaged or has worn seals.
Do not modify the appliance.
SAFETY DEVICE
The appliance is also equipped with a safety device, which
stops gas flow if the pressure in the gas bottle becomes too
high ( because of overheating)
The gas bottle cannot be inserted if the control knob is not in
OFF position or the drip pan is in the transport position.
The appliance is provided with a pressure regulating valve to
reduce gas pressure in order to prevent flaring.
Check the seals( between the appliance and the gas bottle)
are in place and in good condition before connecting the gas
bottle.
Check the seals before connecting a new gas bottle to the
appliance.
Change the gas bottle outside and away from people.
USING THE COOKER FOR THE FIRST TIME
1. Take the pan support out of the packaging and place it in
the correct position. Please take note of the warning sticker!.
2. Open the
gas bottle
cover and insert the
valve heading front, so that the notch points upwards and
aligns with the valve guide.
3. Then press the
gas bottle
stop lever down.
4.Turn the control Knob fully to the left and until the ignition
device clicks.
5.If there is not ignition, repeat this procedure.
6.Adjust the control knob to the required position *if you hear a
"hissing" noise, the
gas bottle
has not beed correctly fitted. If
necessary you should coorect the
gas bottle
with the
gas bottle
position.
AFTER USE
1. Turn the control knob to the OFF position and set the
gas bottle stop lever to the OFF position.
2. In case of emergency, you can also switch the gas bottle
stop lever inmediately to the OFF position.
3.Check that the stove is off before disconnecting the gas
gas bottle .
4. For your own safety, always remove the gas bottle after use.
STORAGE - MAINTENANCE
When the appliance has completely coled down:
* Remove the gas bottle , fit the gas botlle with its protective
and store it in a cool, dry and well ventilation place.
* The appliance should be cleaned of any residues of food
after each use.
* Set the drip pan unit so that drip pan supports are upside
down. The appliance should be store in the protective carying
case provided.
* Do not modify the appliance.
WARNING
This appliance works with B-250 butane
to En417 standars.
Do not use the appliance if it has damaged or has worn seals.
Does not use the appliance wich is leaking, damaged or which
does not operated properly.
Never place two cookers close to each other.
Do not use any pots or pans which cover the
Do not use the appliance without its drip tray support.
The appliance must be opered on a horizontal surface.
After each use, clean any food and especially fat residues
from the appliances.The appliance shall be used away from
flammable materials. Place at least 20 cm away from walls
and 100cms away from ceiling when operating the appliance.
Check the
gas bottle
is empty before replacing it ( shake it to
hear any noise made by the liquid).
Butane
gas bottle
must be changed in a safe place ( e.g.
in open air or in a well ventilated location, preferaly outside,
away from any sources of ignition, such as naked flames,
pilots, electric fires and away from other people.
If there is a leak on your appliance (smell of gas), take it
outside inmediately ( in a well ventilated and flame free
location where the leak may be detected and stopped) if you
wish to check for leaks on your appliance, do it outside.
Do not try to detect leak using flame. Use soapy water.
Do not make any alterations or attemps to repair the unit by
yourself.
In the event of any problems, please conctact our repair
service, or the dealer.
CAUTION!: accesible parts may become very hot. Keep young
children away from the appliance.
TROUBLESHOOTING
Problem
Solution
No gas
Check that you have inserted the
gas bottle
G
as bottle
Shake
No ignition
Clean the burner head with a brush.
gas bottle
, according
gas bottle
shaft.
correctly.
is empty.
gas bottle
.
EN