DWT ABS-12 CLi Manual De Instrucciones página 26

Symbol
power tool designation
Cordless drills / screwdrivers are designed for hole
drilling in wood, plastic and metal, as well as for screw-
ing in and loosening of threaded fastening elements
(screws, bolts, etc�)�
Power tool
components
1 Keyless chuck
2 Battery *
3 Battery lock *
4 LED lamp
5 Torque regulator
6 Step speed selector switch
7 On / off switch
8 Reverse switch
9 Ventilation slots
10 Strap *
11 Belt clip *
12 Screwdriver bit *
13 Power unit *
14 Charger *
15 Screw
16 Magnetic holder *
17 Indicator of the charger *
18 Indicator of the power unit *
19 Indicators of the state of battery charge *
20 Indicator (green) *
21 Indicator (red) *
22 Charger label *
23 Control button of the state of battery charge *
Meaning
A sign certifying that the
product complies with es-
sential requirements of the
EU directives and harmo-
nized EU standards�
Useful information�
Wear protective gloves�
Torque control position:
"Drilling"�
Stepless speed control�
Do not dispose of the power
tool in a domestic waste
container�
DWT
* Optional extra
Not all of the accessories illustrated or described
are included as standard delivery.
Installation and regulation
of power tool elements
Before execution of any procedures, centre the re-
verse switch 8.
Do not draw up the fastening elements
too tight to avoid damaging the thread�
Mounting / dismounting / setting-up of
some elements is the same for all power
tool models, in this case specific models
are not indicated in the illustration�
Mounting / replacement of accessories (see fig. 1)
With long-term use the drill bit may be-
come very warm; use gloves to remove it.
• Open the jaws of the keyless chuck 1, rotating its
front part as shown in figure 1.
• Mount / replace the accessory�
• Tighten the keyless chuck 1 without skewing the ac-
cessory as it is shown in figure 1.
Mounting / dismounting of the keyless chuck (see
fig. 2-3)
• To mount the keyless chuck 1, carry out the op-
erations in consecutive stages as it is shown in fig-
ure 2�
• To dismount the keyless chuck 1, carry out the op-
erations in consecutive stages as it is shown in fig-
ure 3�
Attention: keep in mind that in the pro-
cess of mounting / dismounting of the
keyless chuck 1 the screw 15 has a left-
hand thread.
Screwdriver bit / magnetic holder (see fig. 4)
For short screwdriver bits use the magnetic holder 16
for their reliable fixing (see fig. 4).
A magnetic holder 16 is not needed for extended
screwdriver bits 12 (specially purposed for screw-
drivers)�
of the power tool battery
Initial operating of the power tool
The power tool is supplied with a partially charged
battery 2. Before the first use, the battery 2 must
be fully charged.
Charging process (see fig. 5-8)
• Centre the reverse switch 8�
• Press the battery lock 3 (ABS-12 CLi - two battery
locks 3) and remove the battery 2 (see fig. 5-8).
English
26
Charging procedure