Tripp-Lite P131-06N-2VA-U El Manual Del Propietario página 4

Installation
Note:
• The video port on the same side of the unit as the USB
1. Make sure the power to all devices you are
2. Connect the built-in latching HDMI cable to the
3. Connect the included USB Micro-B cable between
4. Connect the monitor that has the EDID information
5. Connect the 3.5 mm audio port to the audio jack
6. Connect a second monitor to the remaining video
7. Connect the second 3.5 mm audio port to the
8. Turn on the power to the source and displays. The
18-01-069-9337CB.indb 4
Micro-B port is the only port that will transmit EDID
information to the connected source. Connect this port to
the monitor that has the EDID information you wish to use.
connecting is turned off prior to installation.
source video output port.
the unit and a USB port on the source or a USB
wall outlet.
you wish to use to the video output port on the
same side of the unit as the USB Micro-B port
using a VGA cable, such as Tripp Lite's P504-
Series VGA + Audio Cable.
on your monitor or speakers.
output port using a VGA cable, such as Tripp Lite's
P504-Series VGA + Audio Cable.
audio jack on your monitor or speakers.
orange LEDs next to each video output port will
illuminate to indicate the unit is powered on and
transmitting a signal to the connected monitors.
4
1/26/2018 10:23:41 AM