Klipsch Reference On-Ear II Manual De Instrucciones página 3

OSHA GUIDELINES FOR NOISE EXPOSURE LIMITS
Sound Pressure Recommended Maximum Exposure
Level
90dB
92dB
95dB
97dB
100dB
102dB
105dB
110dB
115dB
120dB
EU COMPLIANCE INFORMATION
Eligible to bear the CE mark; Conforms to European
Union Low Voltage Directive 2006/95/EC; European
Union EMC Directive 2004/108/EC; European Union RoHS
Directive 2002/95/EC; European Union WEEE Directive
2002/96/EC; European Union Registration, Evaluation,
Authorization and Restriction of Chemicals (REACH)
Directive 2006/121/EC.
WEEE NOTICE
Note: This mark applies only to countries
within the European Union (EU) and Norway.
Per Day
8 Hours
6 Hours
4 Hours
3 Hours
2 Hours
1.5 Hours
1 Hours
30 Minutes
15 Minutes or less
Avoid as damage may occur
This appliance is labeled in accordance with European
Directive 2002/96/EC concerning waste electrical and
electronic equipment (WEEE). This label indicates that
this product should not be disposed of with household
waste. It should be deposited at an appropriate facility
to enable recovery and recycling.
FCC AND CANADA EMC COMPLIANCE INFORMATION
NOTE: This equipment has been tested and found to
comply with the limits for a Class B digital device,
pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against
harmful interference in a residential installation.
This equipment generates, uses and can radiate radio
frequency energy and, if not in-stalled and used in
accordance with the instructions, may cause harmful
interference to radio communications. However, there
is no guarantee that interference will not occur in a
particular installation. If this equipment does cause
harmful interference to radio or television reception,
which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the
interference by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician
for help.