Kohler SPUN GLASS VESSELS K-2276 Instrucciones De Instalación página 2

SELF-RIMMING INSTALLATION
Determine the faucet centerline location. Consider the
faucet and handle escutcheon diameters, the length of
the spout, and the clearance between the spout and the
lavatory rim.
Calculate the faucet centerline measurement by first
dividing the escutcheon diameter in half, and then add
1/4" (6mm).
NOTE: Round this calculation up to the nearest 1/16"
(2mm), if necessary.
Carefully draw the calculated faucet centerline on the
cut out template. Choose the most suitable location
based upon the following factors:
S
compliance with all state and local plumbing codes;
S
a minimum 2" (5cm) distance from the water stream
to the lavatory rim edge. This is important to ensure
adequate clearance for hand washing (refer to
Fig. #3);
S
a minimum 1/4" (6mm) distance between the faucet
spout and the lavatory rim (refer to Fig. #4).
Redraw the faucet centerline as needed to meet these
criteria. Be sure to use the template line labeled "Rim of
Lavatory".
Draw a line on the cut out template a minimum of 2"
(5cm) behind the faucet centerline. This is the minimum
backsplash locator line.
NOTE: Some Kohler faucets require a minimum of 2 1/2"
(6.4cm) behind the final faucet centerline.
Cut along the backsplash locator line on the template.
A
1010430-2-
Faucet
Centerline
1/4" (6mm) Min.
Countertop
Backsplash
2" (5cm) Min.
Cut-Out Template
Countertop
2
Divide Escutcheon
Diameter in Half, Then
Add 1/4" (6mm)
Fig. #2
Air Gap
2" (5cm) Min.
Fig. #3
2" (5cm) Min.
Fig. #4
Backsplash
Locator Line
Faucet Centerline
Fig. #5
Kohler Co., Kohler, WI U.S.A.