Electrical Connection - Atlantic OCI 345 Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 13
OCI 345 Communication module - Kit installation
2. SUPPLY
The OIC 345 module is made up of:
3. INSTALLING THE COMMUNICATION MODULE
The module is mounted on the LMS boiler controller located in the VARMAX control
panel.
-
instructions)
-
instructions).
- Secure the module onto the boiler controller using the 2 screws provided.
- Connect the communications web from the module to the boiler controller X11 connector.
!

4. ELECTRICAL CONNECTION

4.1. Cables
If a cable is damaged, it must be replaced by the manufacturer, its after-sales service or
a similarly qualifi ed person to avoid any possible danger.
LPB Bus
To reduce the risk of pulling on cables, please use the cable clamps located on the boiler.
Page 6 / 24
• 1 interface unit (pre-fi tted with a communications web)
• 2 screws fi xing
DANGER :
Open the door trim on the front of the boiler (see boiler installation and operating
Go to the control panel and remove the cover (see boiler installation and operating
ATTENTION:
Cable
Prior to any work, ensure that the electrical supply is
cut off .
The connector is fragile, proceed with caution.
Copper conductors
2 x 0,5 mm²
Cable raceway
Low current
00BNO9056-#_EN

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

059752

Tabla de contenido