Installation Instructions - Phase Linear PCD161 Manual Del Usario

PCD161

INSTALLATION INSTRUCTIONS

Installation Using a Mounting
Sleeve
1. Slide the mounting sleeve off the chassis. If
it is locked into position, use the removal
tools (supplied) to disengage it.
2. Check the dashboard opening size by slid-
ing the mounting sleeve into it. If the opening
is too small, carefully cut or file as necessary
until the sleeve easily slides into the open-
ing. Do not force the sleeve into the opening
or cause it to bend or bow. Check for suffi-
cient space behind the dashboard for the
radio chassis.
3. Locate the series of bend tabs along the top,
bottom, and sides of the mounting sleeve.
With the sleeve fully inserted into the dash-
board opening, bend as many of the tabs
outward as necessary to firmly secure the
sleeve to the dashboard.
4. Place the radio in front of the dashboard
opening so the wiring can be brought
through the mounting sleeve. Follow the wir-
ing diagram carefully and make certain all
connections are secure and insulated with
wire nuts or electrical tape. After completing
the wiring connections, turn the unit on to
confirm operation (vehicle ignition must be
"on"). If the unit does not operate, re-check
all wiring until the problem is corrected.
5. Make sure the radio is right-side up, then
carefully slide the radio into the mounting
sleeve until it is fully seated and the spring
clips lock it into place.
6. Attach one end of the perforated support
strap (supplied) to the screw stud on the rear
of the chassis using the hex nut provided.
Fasten the other end of the perforated strap
to a secure part of the dashboard either
above or below the radio using the screw
provided. Bend the strap to position it as
necessary.
7. Test the radio using the Operating Instruc-
tions that follow.
CAUTION: The support strap
must be used to prevent
damage to the dashboard from
the weight of the radio or
improper operation due to
vibration.
CAUTION: For proper operation
of the CD player, the chassis
must be mounted within 20° of
horizontal. Make sure the unit is
mounted within this limitation.
INSTALLATION
PM
P
I
/MP RE
EI ER
S
M
BA O
D D
E
CD V
R
DO
ME
BEND TABS