Paso 12 Preparación De Las Piezas Del Hotend; Paso 13 Hotend Assembly - Prusa i3 MK2 Manual Del Usuario

PASO 12 Preparación de las piezas del hotend
Para los siguientes pasos, prepara:
Hotend para la MK2.5S (1x)
Tornillo M3x40 (2x)
Tornillo M3x10 (x2)
Usaremos algunos tornillos más tarde, pues tenlos alrededor.
PASO 13 Hotend assembly
Take two M3x10 screws and insert them in the holes. Doing this now makes the
assembly slightly easier, but both holes are shallow and the screws might fall out. If
this happens, you can continue without them and put them back later on (you will
be noticed). Also note, that in few upcoming pictures the screws might be missing.
Hotend assembly was completely reworked from MK3 to avoid bad placement. Also
any future maintenance is much easier.
Place the hotend next to the Extruder-body, see the grooves in the printed part,
which are in the shape of the hotend.
Correctly placed hotend. Cables should point in the direction behind the hand, we
will align them in the next step.
28
3. Montaje del extrusor
Original Prusa i3 MK2 to MK2.5S upgrade