Overview Of Screens & Icons - Finder BLISS2 Manual Del Usuario

OVERVIEW OF SCREENS & ICONS
ROOM TEMPERATURE
Thermostat is set to AUTOMATIC
mode (AUTO) and will respond to
programming via the App.
Current room temperature is
displayed.
TARGET TEMPERATURE IN
MANUAL MODE
The thermostat is set to
MANUAL mode.
The target temperature is
displayed.
MANUAL MODE
Thermostat is set to Manual mode.
If the small arc segment at the top
is coloured, the heating or cooling
system is active.
If red - heating If blue - cooling.
HOURS SETTING
This displays the number of
hours for which the manual
mode is to apply. From 1 hour
(h01) to permanent (h∞).
FULL ARC
Appears when a setting
is accepted and when the
heating or cooling
system is active.
HUMIDITY DETECTED IN THE
ATMOSPHERE
In this section you can opt to
view the level of humidity in the
atmosphere (% RH).
%RH
Display of Relative Humidity
currently present in the
atmosphere.
ON/OFF SECTION
In this section you can turn
the thermostat ON or OFF.
ON MODE
With ON mode selected, the
thermostat can function in
either AUTO or Manual modes.
OFF MODE
With the OFF mode selected,
the thermostat will still maintain
a frost protection setting of + 5°C
to avoid freeze damage to the system.
3
SETTINGS MENU
From here you can access the
device settings.
ASSOCIATION WITH THE GATEWAY
The opposing arrows will flash only
during the gateway pairing procedure.
TRANSMISSION TEST WITH THE GATEWAY
At this point in the menu you can perform
a signal transmission test between the
gateway and the thermostat.
RESULT OF THE TRANSMISSION TEST WITH THE
GATEWAY
0 SIGNAL ABSENT: the gateway is unreachable
1/6 POOR: bring the two devices closer
7/8 GOOD: make changes only if errors are found
9/10 VERY GOOD: stable connection.
FIRMWARE VERSION
At this point in the menu it is possible to
view the firmware version present on the
device.